- 10. What is IPS display? Open
AMA is short for Advanced Motion Accelerator. It' new technology to give greater voltage to liquid crystal, BenQ improve the gray to gray response time and image became clearer and more vivid.
ECO sensor detects users' presence in front of the monitor within the set range. If the sensor detects no presence, the monitor is turned off in 40 seconds to save power. If the monitor is turned off by the ECO sensor, the power button flashes in green. If the ECO sensor detect no presence for over 2 hours, the monitor will be powered off. Press the power button to turn on the monitor.
Yes, M2400HD can display picture via DVI or HDMI as connected to CANOPUS HD STORM capture card.
Sun lotion or other oily substances may discolor the camera body. If this happens, please clean the camera body immediately with damp cloth.
P stands for “preset mode” and is the preferred setting. NP is ""Non Preset"" mode that the monitor supports and image can be displayed. FS: Fail Save Mode. The image can still be displayed but may not be able to displayed correctly because it’s out of range. ""Out of Range"" will be shown. O: Out of Range. The monitor does not support, and no picture would be shown. Therefore, the resolution with P is the preferred setting.
You may position the screen to the desired angle with -5° to +20° monitor tilt, 90° (left and right total) monitor swivel, and 130 mm monitor height.
How to fully utilize the energy of the battery.
DisplayPort is a digital display interface standard produced by the Video Electronics Standards Association (VESA). The specification defines a royalty-free digital interconnect for audio and video. The interface is primarily used to connect a video source to a display device such as a computer monitor or television set. The first version 1.0 was approved by VESA on May 3, 2006. Two updated revisions have since been approved starting with 1.1a on April 2, 2007 followed by the current standard 1.2 on December 22, 2009. DisplayPort is designed to replace Digital Visual Interface (DVI) and Video Graphics Array (VGA), as well as replace internal digital LVDS links in computer monitor panels and TV panels. DisplayPort can also provide the same functionality as HDMI but is not expected to displace HDMI in high-definition consumer electronics devices. Most of the DisplayPort supporters are computer companies including Apple, Dell, HP, Lenovo, Fujitsu, Toshiba and Acer, some of which have released several computer monitors that support DisplayPort and some also with HDMI. In December 2010 it was announced that several computer vendors and display makers including Intel, AMD, Dell, Lenovo, Samsung and LG would stop using LVDS from 2013 and legacy DVI and VGA connectors from 2015, replacing them with DisplayPort and HDMI. Likewise, HP expects that DisplayPort will completely displace VGA and DVI by 2013. However, many are still using those connectors, so it doesn't seem to have much effect right now. Most laptops still have HDMI and legacy VGA ports, but not DisplayPort or DVI. In 2010, BenQ launched BL2201PT, BL2201PU, BL2400PT & BL2400PU that support DP 1.1a.
8~10 frames per second.
IPS stands for In-plane switching. In-plane switching was developed by Hitachi Ltd. in 1996 to improve on the poor viewing angle and the poor color reproduction of TN panels at that time. Its name comes from the main difference from TN panels, that the crystal molecules move parallel to the panel plane instead of perpendicular to it. This change reduces the amount of light scattering in the matrix, which gives IPS its characteristic wide viewing angles and good color reproduction. Initial iterations of IPS technology were plagued with slow response time and a low contrast ratio but later evolutions have made marked improvements to these shortcomings. Because of its wide viewing angle and accurate color reproduction (with almost no off-angle color shift), IPS is widely employed in high-end monitors aimed at professional graphic artists, although with the recent fall in price it has been seen in the mainstream market as well.
"1. Set the mode dial to the desired shooting mode. 2. Press ""flower"" of the 4-way control and use left / right of the 4-way control to select your desired setting. 3. Press ok to confirm."
"Performs delay and capture twice: Performs a 10-second delay, then captures the image. Performs another 2-second delay then captures the image again."
You can use this mode to create a panoramic photo from multiple shots. You can combine several shots into one single image quickly and easily.
Shutter priority is often used when shooting moving subjects. In general, use a shorter shutter speed to catch a fast-moving object.
"You can choose an aperture value, while the shutter speed is automatically determined by the lighting condition of the subject."
When the video size is set to 1920x1080p@15fps (2X, 18Mbps), the video is recorded at normal speed (up to 25 minutes). However, the playback is two times faster than the normal playback.
The 2 lots support for each 32G of SDHC card separately.
GH800 is telephoto lens and will not support adding interchangeable lenses.
Please ensure to move the DV charging under the high temperature for charging the battery and it should be over 10 degree.
It's under normal condition and within BenQ's specification.